Why is the "Cost of Inspection" wrong on the "Cost Savings Report" page?

The calculations made on the “Cost Savings Report” page are based on the information entered on image pages and "Cost of Inspection" field. apply to Electrical and Mechanical reports only.
Written by Support Manager
Updated 2 years ago

Note:  Cost Savings Report page applies only to Electrical and Mechanical reports.

To add or correct the “Cost of Inspection”, go to the “Finish Report” option located on the right side of your report screen. 

The field “Cost of Inspection” is found toward the bottom of the “Finish report” page.   Enter the value as a whole number only (no $ or decimal point).

The entered value will appear on the “Cost Savings Report” page on the completed PDF. 

NOTE:  If you do not want to show the cost of the inspection in the report, but want to show the possible cost of losses, leave the “Cost of Inspection” field blank. 

Did this answer your question?